The new season editDiscover the latest pieces
AUREL

Size Guide

A more considered fit

Use these methods as a practical starting point for rings, necklaces, and bracelets. Product dimensions and available variants always take precedence over general guidance.

Before you measure

  • Use millimetres for ring measurements and centimetres for chain and wrist measurements.
  • Measure more than once and use the same method each time.
  • Do not pull paper, string, or measuring tape so tightly that it compresses the skin.
  • Body temperature and time of day can affect finger and wrist measurements.
  • If a product has an unusual width or construction, ask client care for product-specific guidance.

01 / Rings

Find your ring size

For the most reliable result, compare both a ring that already fits and a direct finger measurement.

Method A: measure an existing ring

  1. Choose a ring that fits the intended finger and sits comfortably over the knuckle.
  2. Place it on a flat surface and measure the inside diameter from inner edge to inner edge.
  3. Record the diameter in millimetres without including the metal band.
  4. Compare the result with the diameter column in the conversion table.

Method B: measure your finger

  1. Wrap a non-stretch strip of paper or a flexible measuring tape around the widest part of the intended finger.
  2. Keep the fit comfortable and mark where the ends meet.
  3. Lay the strip flat and measure the length in millimetres. This is the finger circumference.
  4. Repeat at least twice and compare the result with the circumference column.

Ring fit notes

  • Measure near the end of the day when fingers are typically less cool.
  • A wider band can feel closer than a fine band at the same nominal size.
  • If the knuckle is noticeably wider than the finger base, consider both measurements.
  • For a surprise gift, measure a ring worn on the same finger rather than estimating from appearance.
Approximate international ring size conversion
US sizeInside diameter (mm)Inside circumference (mm)UK sizeEU size
414.946.847
515.749.349
616.551.952
717.354.454
818.157.057
918.959.560
1019.862.162

Conversions are approximate because sizing standards can vary by manufacturer and market. Use the product variant label and confirmed measurements when available.

02 / Necklaces

Choose a necklace length

Placement changes with neck circumference, height, pendant dimensions, clothing, and layering. Test the length with a soft cord before ordering.

  1. Cut a soft cord to the listed chain length.
  2. Place it around the neck without pulling it tight.
  3. Mark the centre point if the design includes a pendant.
  4. Check the placement with the neckline and any pieces you plan to layer.
General necklace length reference
LengthApproximate placementConsider for
40 cm / 16 inNear the base of the neckA close, clean line
45 cm / 18 inAround the collarboneEveryday pendants and layering
50 cm / 20 inBelow the collarboneMore space around the neckline
55 cm / 22 inUpper chestLonger pendants and relaxed layering
60 cm / 24 in and longerMid-chest or lowerExtended silhouettes

Placement is illustrative, not guaranteed. Refer to the listed chain length and pendant dimensions for each product.

03 / Bracelets

Measure your wrist

  1. Wrap a flexible measuring tape around the wrist where the bracelet will sit.
  2. Keep the tape in contact with the skin without compressing it.
  3. Record the wrist circumference in centimetres.
  4. Add an allowance based on your preferred fit and the product construction.

Rigid bracelets and cuffs

For a closed bangle, the hand circumference and internal bangle dimensions may matter more than wrist circumference. For a cuff, check the opening, internal width, and intended adjustment guidance on the product page.

Suggested starting allowance
Fit preferenceAdd to wrist measurementFeel
Close1.0–1.5 cmMinimal shifting
RegularAbout 2.0 cmComfortable everyday ease
RelaxedAbout 2.5 cmLooser drape

These allowances are general. Cuffs, rigid bangles, wide designs, and adjustable constructions require product-specific guidance.

Next step

Need a second opinion?

Send your measurements and the product name to client care before ordering.